PowerDot PD-01 Instruction Manual page 27

Hide thumbs Also See for PD-01:
Table of Contents

Advertisement

POWERDOT MAINTAINENCE INSTRUCTIONS 
As general recommendation, PowerDot should be switched OFF and lead detached from the connector 
at  the  end  of  every  session  (if  user  forgets to  switch  off,  PowerDot  will  switch  off  itself  automatically 
after 20 minutes of inactivity).   
PowerDot  unit,  together  with  its  accessories,  should  be  kept  in  the  carry  case  supplied  and  carefully 
stored on a secure surface and protected from the situations, listed in the WARNINGS above.  
 WARNING! Replace your electrode pads after 25‐30 usages as recommended. Deteriorated & worn 
out  pads  can  cause  major  discomfort  during  stimulation,  affect  the  effectiveness  and  even  lead  to 
minor injury. 
 WARNING! Cleaning: only clean the unit using a dry soft cloth. 
 WARNING! Keep device and pads out of the water and store them in dry conditions in protective 
packaging or in the PowerDot carry case.  
 WARNING! Disconnect lead wire from PowerDot unit AND lead snaps form the pads when storing 
them in the carry case. Otherwise, the leads might bend excessively close to the connectors and this 
may either  damage the leads or significantly reduce their lifetime.  
PowerDot  stimulators  do  not  require  calibration  or  verification  of  performance  parameters.  The 
characteristics  are  systemically  verified  and  validated  for  each  device  manufactured.  Those 
characteristics are stable and do not vary when used under normal conditions. 
The  manufacturer  states  that  PowerDot  unit  cannot  be  repaired  by  personnel  external  to  its  own 
company. Any work of this nature carried out by personnel not authorized by the manufacturer will be 
classified as tampering with the unit, freeing the manufacturer from responsibility for the warranty and 
hazards that the operator or user may be exposed to.  
ELIMINATION 
European Directive 2002/96/CEE (WEEE) has a first priority, the prevention of waste electrical and 
electronic equipment, and in addition, the re‐use, recycling and other forms of recovery of such wastes 
so as to reduce the disposal of waste: 
the pictogram wheeled bin barred means that the equipment can't be thrown with the 
household refuse, but that it makes the object of a selective collection 
the equipment has to be given to a suitable collection point for the treatment 
by this way, you contribute to the safeguarding of the natural resources and the human health 
protection 
27 

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PD-01 and is the answer not in the manual?

Table of Contents