PowerDot PD-01 Instruction Manual page 14

Device Deactivation
PowerDot can be deactivated and reset back to its factory state either programmatically or manually.
For manual deactivation, make sure device is ON and not in stimulation, then hold Multi‐Function Tactile
Button for 10 seconds till you see Power/Stimulation LED blinking BLUE 3 times.
Programmatic deactivation can be done from Device Setup menu. Just use Deactivate button next to the
relevant device, but the device should be powered ON before it can be deactivated.
Pre‐Stimulation Assembly & Placing On a Body
Before placing PowerDot on a body, it's always easier to pre‐assemble PowerDot:
1) Snapping on your PowerDot unit to your currently used rectangular pad (while pad is staying
attached to its storage/carrying piece of film).
2) Plugging selected relevant lead into PowerDot micro‐USB socket;
WARNING! ALWAYS visually inspect leads and PowerDot units for any damage BEFORE every
stimulation session. Do not use damaged accessories or units, consider replacing them
immediately.
3) Snapping on round pads to your lead (while pads are staying attached to their storage/carrying
film). Alternatively, you can place round pads on body first and snap lead snap connectors to
them while they're on the body.
4) Unstick both round pads from their safety films and place them on your body in accordance your
mobile application pads placement recommendation.
5) Unstick rectangular pad from its safety film and attach it to the relevant position on your body
(in accordance with your mobile application pads placement recommendation).
14