Federal Signal Corporation Valor Low-Profile Hook Manual

25500364A A1 0820
Safety Message to Installers of Federal Signal Warning Light Systems
People's lives depend on your proper installation and servicing of Federal Signal products. It is important
to read and follow all instructions shipped with this product and the original product. Listed below are
some other important safety instructions and precautions you should follow.
• To properly install a light assembly, you must have a good understanding of automotive electrical
procedures and systems, along with proficiency in the installation and use of safety warning
equipment.
• Frequently inspect the light system to ensure that it is operating properly and is securely attached to
the vehicle.
• Always refer to the vehicle service manuals when performing equipment installations on a vehicle.
• When drilling into a vehicle structure, enure that both sides of the surface are clear of anything that
could be damaged.
• Locate the light system controls so the VEHICLE and CONTROLS can be operated safely under all
driving conditions.
• If a vehicle seat is temporarily removed, verify with the vehicle manufacturer if the seat needs to be
recalibrated for proper airbag deployment.
• Do not install equipment or route wiring in the deployment path of an airbag. Failure to observe this
warning will reduce the effectiveness of the airbag or potentially dislodge the equipment, causing
serious injury to you or others.
• To avoid damage to the light bar, do not overtighten screws and nuts.
• This product contains high intensity LED devices. To prevent permanent eye damage, DO NOT stare
into the light beam at close range.
• For additional precautions and information, refer to the instructions packed with related products.
• File these instructions in a safe place and refer to them when maintaining or reinstalling the product.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death.
Introduction
This publication provides instructions for installing the Valor light bar to a vehicle with the Low Hook-On
Mounting Kit. To complete the installation, it is necessary to purchase a vehicle-specific mounting hook
kit.
Unpacking the Kit
After unpacking the kit, inspect it for damage that may have occurred in transit. If it has been damaged,
file a claim immediately with the carrier, stating the extent of the damage. Carefully check all envelopes,
shipping labels, and tags before removing or destroying them. Ensure that the parts shown in Table 1 are
contained in the packing carton. If you are missing any parts, contact Customer Support at 1-800-264-
3578, 7 a.m. to 5 p.m., Monday through Friday (CT).
Valor Low-Profile Hook Mount Manual
®