Federal Signal Corporation IPX-PB45H Installation Instructions

2562406B REV. B 611
Safety Message to Installers of Warning Light Equipment
People's lives depend on your safe installation of our products. It is important to read, understand and
follow all instructions shipped with the products. In addition, listed below are some other important safety
instructions and precautions you should follow:
• To properly install a light assembly, you must have a good understanding of automotive electrical
procedures and systems, along with proficiency in the installation and use of safety warning equipment.
• Before drilling into a vehicle structure, be sure that both sides of the surface are clear of anything that
could be damaged.
• If a vehicle seat is temporarily removed, verify with the vehicle manufacturer if the seat needs to be
recalibrated for proper airbag deployment.
• This product contains high intensity LED devices. To prevent permanent eye damage, DO NOT stare
into the light beam at close range.
• You should frequently inspect the light system to ensure that it is operating properly and that it is
securely attached to the vehicle.
• Refer to the instructions packed with related products for additional precautions and information.
• File these instructions in a safe place and refer to them when maintaining or reinstalling the product.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death.
Mounting Bracket for IMPAXX
This publication has instructions for using the IPX-PB45H (horizontal) and IPX-PB45V (vertical) brackets
for mounting I or V
mpaxx
requires the hardware that came with the lightheads to attach them to the mounting bracket.
Unpacking the Kit
After unpacking the kit, inspect it for damage that may have occurred in transit. If it has been damaged, do
not attempt to install or operate it. File a claim immediately with the carrier, stating the extent of damage.
Carefully check all envelopes, shipping labels, and tags before removing or destroying them. Ensure that the
parts listed in Table 1 are included in the package. If you are missing any parts, contact Customer Support at
1-800-264-3578, 7 a.m. to 5 p.m., Monday through Friday (CT).
and Viper
®
EXT lightheads on a push bumper or other flat surface. This installation
Iper
Table 1 Kit contents
Qty. Description
2 Bracket, 45 Horizontal
OR
2 Bracket, 45 Vertical
4 Screw, #10 Type B
Installation Instructions for the IPX-PB45H
and IPX-PB45V Mounting Bracket Kits
EXT
®
Part Number
8613173
8613222
7011A122-06