AL-KO 2000i Manual page 25

Important! Danger of burns!
Parts of the generator become very hot during
operation and remain hot even after the genera-
tor is switched off.
Hot exhaust gases discharge from the exhaust
gas silencer
5. Unscrew screws (
6. Remove engine cover (
7. Unscrew the oil filling lid and store it in a clean
place. (
4/1)
8. Place an oil collection container under the engine.
9. Tilt the generator to fully drain the oil.
10. Place machine again on an even horizontal surface.
Observe filling amount and oil grade (see operat-
ing materials)
Important!
Do not tilt the generator while filling it with oil -
Filling beyond the maximum filling level can dam-
age the engine
11. Add new engine oil (
level (
6)
„ If engine oil has leaked out:
Do not start the engine
„
Absorb leaked engine oil using an oil binding
„
agent or cloth and dispose properly
Clean the machine
„
12. Clean and tightly close the oil filling lid.
13. Insert and tighten engine cover
Do not dispose of waste oil:
„ in domestic waste
„ by pouring it into the canalisation, drain, or
onto the ground
Drop off waste oil in a closed container at a recycling
centre or a customer service centre.
Cleaning the fuel tank screen
Important – Danger of explosion!
Do not smoke and no naked flames when
handling petrol
1. Unscrew the fuel tank lid.
478 067_e
3/1)
3/2)
5), observe maximum filling
(
18)
2. Remove the fuel tank screen
3. Clean the fuel tank screen using petrol
4. Rub fuel tank screen dry
5. Insert fuel tank screen
„ If petrol has leaked out:
Do not start the engine
„
Avoid start attempts
„
Clean the machine
„
Have engine cool down before refilling with
„
petrol to avoid spilling
Spilled fuel can lead to damage to plastic parts.
„
Immediately wipe off fuel. Warranty does not
cover damage to plastic parts caused by fuel
6. Tightly close the tank filling opening
Changing the spark plug
1. Remove the cover from the housing (
2. Disconnect the spark plug connector (
3. Attach the spark plug wrench (
opening to the spark plugs
4. Insert bar ( 20/3) through the spark plug wrench
(
20/4)
5. Unscrew spark plug by turning the spark plug
wrench
6. Insert new spark plug
Observe the spark plug type (see Technical data)
7. Tighten the spark plug using the spark plug wrench
Observe the torque! 20 Nm
8. Remove the spark plug wrench
9. Install the cover to the housing
Maintenance intervals
Before every use
„ Check the engine oil level
„ Inspect the air filter
„ Visual inspection for damage
After 20 operating hours or 1 month after first use
„ Oil change
GB
19/1)
19/2)
20/4) through the
25