Teledyne 5800 Instruction Sheet page 5

60-4702-009 Revision D, June11, 2020
Figure 11: Position drain tube in front half of drip pan.
2. Reinstall the refrigeration module, tipping the
top back while sliding the bottom forward. When
the bottom is in place, push the top into place.
Figure 12: Slide refrigeration module into place
CAUTION
When reinstalling all self-tapping screws, avoid
destroying the plastic threads. First seat each screw in
its hole and, without pressing down, rotate the screw
counter-clockwise until it falls into its thread groove with
a "click." Then tighten the screw.
3. Reinstall the refrigeration module mounting
screws (8), insulation panel/back cover screws
(5), and cover brace screws (2).
Figure 13: Old version
When installing/replacing the refrigeration unit, the line
cord MUST be properly secured. This is to ensure that
the cord cannot be pushed into the enclosure and be
Push top in
caught in the fan.
second.
Push
Figure 14: Attach cable tie to line cord
bottom in
first.
5
Refrigeration
module
Insulation
panel
Back
cover
Cover
brace
CAUTION
4. Hold the line cord taut to remove any slack, and
attach a cable tie 489-0110-00, as shown below.
5. Restore AC power to the refrigerator.
6. After 45 minutes, perform the refrigerator
temperature diagnostic test, as described in
the section 4. Refrigerator Temperature Diag-
nostic at the end of this document.
Attach cable tie