The Functions Of Controller Display - COMFORTPOOL PRO+5 Installation Instructions Manual

14
- Press "Mode" again "E" "40". Press "SET" to enter Max. temp. setting. Press  to alter. Press "SET" again to
confirm.
- Press "Mode" again "F" "2". Press "SET" to enter Split temp. setting. Press  to alter. Press "SET" again to
confirm.
- Press "Mode" again "G" "-10". Press "SET" to enter Ambient temp. protection setting. Press  to alter. Press
"SET" again to confirm.
Further explanation of PCB connections.
4. Clock setting
Under running or standby status, press "SET" for 5 seconds, get a sound "B". Press to alter hour. Press "SET"
again to alter minute. Press "SET" again to confirm.
5.Timer setting
Under running or standby status, press  for 5 seconds, get a sound "B". Press  to alter hour of timer ON. Press
 again to alter minute of timer ON. Press  again to alter timer OFF.
103

5.2 The functions of controller display

Setting operation parameter
Under standby status, press "Mode" button 5 sec. to enter Operation Parameter setting interface;
Press "Mode" again to start setting (parameter from 00-D, see the Operation Parameter Table);
Under parameter setting. Press  or  to set data;
Note: If no motion is detected on the display for 10 sec, the LCD will display water-in/water-out temp.
(under running) or ambient temp. (under standby status).
Under running status, you can press "Mode" 5 sec to check current parameter, but you cannot change data
of parameter!
Remarks: Standby status means the unit is connected to electricity, but is not running.