Lcd Controller Display; Setting Step - COMFORTPOOL PRO+5 Installation Instructions Manual

5. LCD Controller Display

5.1 Setting step

1. Under running status, press  to adjust the temperature.
2. Press "Mode" to choose the mode:
3. Press "Mode" again
4. Press "Mode" again
5. Standby status:
Warning! These default settings are correctly preset. Only allow a qualified heat pump technician to change them.
- Press "Mode" 5 seconds, get a sound "B", LCD display will show "0" "27". Press "SET" to enter Cooling temp. setting.
Press  to alter cooling temp. Press "SET" again to confirm.
- Press "Mode" again "1" "27". Press "SET" to enter Heating temp. setting. Press  to alter heating temp. Press
"SET" again to confirm.
- Press "Mode" again "2" "40". Press "SET" to enter Defrosting time setting. Press  to alter defrosting time. Press
"SET" again to confirm.
- Press "Mode" again "3" "-7". Press "SET" to enter Defrosting temp. setting. Press  to alter defrosting temp. Press
"SET" again to confirm.
- Press "Mode" again "4" "13". Press "SET" to enter Exit defrosting temp. setting. Press  to alter exit defrosting
temp. Press "SET" again to confirm.
- Press "Mode" again "5" "8". Press "SET" to enter Exit defrosting time setting. Press to alter exit defrosting time.
Press "SET" again to confirm.
Press "Mode" again "6" "1". Press "SET" to enter System quantity setting. Press  to alter system quantity. Press
"SET" again to confirm.
- Press "Mode" again "7" "1". Press "SET" to enter Automatic setting. Press to alter. Press "SET" again to
confirm.
- Press "Mode" again "8" "1". Press "SET" to enter Mode setting. Press  to alter. Press "SET" again to confirm.
- Press "Mode" again "9" "0". Press "SET" to enter Water pump setting. Press  to alter. Press "SET" again to
confirm.
- Press "Mode" again "A" "40". Press "SET" to enter Return water temp. setting. Press  to alter. Press "SET" again
to confirm.
- Press "Mode" again "B" "5". Press "SET" to enter Overheat protection (heating mode) setting. Press  to alter.
Press "SET" again to confirm.
- Press "Mode" again "C" "35". Press "SET" to enter Electronic expansion valve setting. Press  to alter. Press
"SET" again to confirm.
- Press "Mode" again "D" "5". Press "SET" to enter Overheat protection (cooling mode) setting. Press  to alter.
Press "SET" again to confirm.
cooling
heating
13