Table of Contents
Advertisement
These paragraphe explains how to create, modify and save a welding program. Hereunder is explained the common menu used.
1)
Activate program management mode SETUP à PGM à put YES à exit SETUP
2)
Set your program with commutators then long push on button OK
3)
Screen displays message as following:
Function selection:
rEC: Save program
Ld: Load program
cod: Activate locking
code
Cancel action in
progress.
NOTE : The DIGISTEEL III 320C / DIGIPULS III 320C allows to lock program menu. This function is available on program screen with the parameter cod.
The locking key entered has to be written in order to desactivate the function lock.
3.3.5. Program call with trigger
This function allows to chain from 2 to 10 programs. This function is available in 4T welding mode only and program management mode has to be activated
Program chaining :
The function program call works with programs from P50 to P99 by ten.
ð P50àP59 ; P60àP69 ; P70àP79 ; P80àP89 ; P90àP99
Selec first program with which you want to begin your chain. Then during welding, each time you will push trigger, program will change.
To chain less than ten programs, in the program following end of loop desired put a different parameter (As synergy or welding cycle).
It is possible to setup time of trigger push to detect change of program chain : SETUP à CPT à put value from 1 to 100 à exit SETUP
Example: Create a program list from P50 to P55 (6 programs).
1)
In program P56, put different welding cycle or synergy than P55 in order to finish chain
2)
Select program P50 (First program for start of welding
3)
Start welding
4)
Each time trigger will be pushed, power source will change program until P55. When chain is finished, power source will restart to P50.
DIGISTEEL III 320C / DIGIPULS III 320C
EN
Program number
selection.from P01 to
P99.
P00: Cancel program
mode
Validate action in
progress
11 / 28
Advertisement
Table of Contents
