Advertisement

Quick Links

Instructions for use for the washable nasal and ear hair
trimmer.

1. Protecting cap

2. Stainless steel cutting system

3. Cutting head.

4. BIPIN-lamp:

5. OWOFF switch

6. Battery cover

IMPORTANT SAFETY INSTRUCTIONS

When using a battery operated appliance, basic safety precautions
should always be followed, including the following. Read all
instructions before using the product.
When using a battery operated appliance, basic safety precautions
should always be followed, including the following. Read all
instructions before using the product.
SAFETY
You trimmer is an electrical device, please pay attention to the
following safety instructions:
• Only use the trimmer as described in this manual
• Ensure tight seat of the cutting head(3).
• Not suitable for children and keep out of reach of children.
• This is a washable product. It can be cleaned easily and safely
under running water. However.
• Do not immerse the trimmer in water.
• Check the trimmer for mechanical damaged. A damaged cutter
may result in injury.
1. Protecting cap
2. Stainless steel cutting system
3. Cutting head
4. BIPIN-lamp

5. ON/OFF switch

6. Battery cover

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GC4116 and is the answer not in the manual?

Questions and answers

Summary of Contents for Grundig GC4116

  • Page 1 1. Protecting cap 2. Stainless steel cutting system 3. Cutting head 4. BIPIN-lamp 5. ON/OFF switch 6. Battery cover Instructions for use for the washable nasal and ear hair trimmer. 1. Protecting cap 2. Stainless steel cutting system 3. Cutting head. 4.
  • Page 2 • The equipment meets the requirements of the EU guideline on Electromagnetic Compatibility (EMC) 89/336/EEC. Battery installation / replacement Holding the trimmer upside down. Rotate the battery cover counterclockwise until the cover unlocks from the unit. Insert one AA alkaline battery compartment, positive side up. Replace the battery cover and turn clockwise to snap into place.
  • Page 3 Trimming ear hair Clean outer area of ear and make sure it is free of wax. Pull ear flat to head with one hand and hold trimmer with the other. Turn trimmer on and move tip around edges of ear to remove hairs extending beyond the outer ear.
  • Page 4 For more though cleaning, remove cutting head assembly (unscrew in clockwise direction) and rinse under running water to remove hairs from inside of assembly. After cleaning, return cutting head assembly to its original position (turn counter-clockwise) and wipe entire trimmer dry with soft cloth. Always replace protecting cap before storing the trimmer.

Table of Contents