Cleaning And Maintenance; Troubleshooting - BOMANN KS 2261 Instruction Manual

Cleaning and Mainten Cleaning
Cleaning Cleaning
WARNING: WARNING: WARNING: WARNING:
• Always disconnect the appliance from the power
supply before cleaning and user maintenance.
• Do not use steam cleaners for cleaning the appli-
ance; moisture could enter electrical components.
Risk of electric shock! Risk of electric shock! Hot steam could damage Risk of electric shock! Risk of electric shock!
the plastic parts.
• The appliance must be dry before restarting oper-
ation.
CAUTION: CAUTION: CAUTION: CAUTION:
• Do not use a wire brush or other sharp, abrasive
items.
• Do not use any acidic or abrasive detergents.
• Do not damage the refrigerant circuit.
Cleaning the appliance includ Cleaning the appliance including interior Cleaning the appliance includ Cleaning the appliance includ
• Clean the appliance interior, the exterior surfaces,
the accessories and the door seal regularly with
warm water and mild detergent; or with a clean,
damp microfibre cloth without cleaning agent.
• Remove the appliance content and storage it at a
cool location.
• After everything was thoroughly dried, you can
restart the operation.
Defrosting Defrosting
Defrosting Defrosting
CAUTION: CAUTION: CAUTION: CAUTION:
Never use metal objects (e.g. knifes) to remove ice
from the evaporator. Otherwise it can be damaged.
A defect evaporator can cause serious damage.
To achieve better cooling and to save energy, defrost
the appliance regularly manual as follows:
• To start the defrosting process turn the tempera-
ture control to the off state and disconnect the
appliance from the power supply.
• Remove the food items and keep covered at a
cool location.
and Maintenance ance
and Mainten and Mainten ance ance
ing interior ing interior ing interior
• Once the ice has melted, empty the condensation
drip tray below the chilling compartment; wipe up
the condensation water and dry the interior.
• Then you may restart the appliance by connecting
the plug and turning the temperature control.
Changing the bulb Changing the bulb Changing the bulb Changing the bulb
Lamp data: max. 1 Lamp data: Lamp data: Lamp data: max. 1 max. 10 0 0 0 W / 220 max. 1
• Remove the condensate drip tray beneath the
chilling compartment.
• Loosen the screw and remove the remove the
lamp cover carefully.
• Change the defective bulb.
• Replace the lamp cover properly and fix it.
• Insert the condensate drip tray back into its origi-
nal position.

Troubleshooting

Troubleshooting Troubleshooting Troubleshooting
Before you contact an authorized specialist Before you contact an authorized specialist
Before you contact an authorized specialist Before you contact an authorized specialist
Problem Problem Cause / Action Cause / Action
Problem Problem Cause / Action Cause / Action
Appliance is ∙ Check the power supply / temperature
not working setting / ambient temperature.
properly or ∙ Unblock the ventilation openings,
at all install the appliance freely.
Loading is ∙ Check the temperature setting / ambi-
too warm ent temperature. ∙ Open the door only
as long as necessary.
Loud noise ∙ Check the appliance position.
during oper- ∙ See the section "Operating noise".
ation
Water on the ∙ Check the temperature setting / the
appliance
condensation drip tray.
bottom
Light does ∙ Check the power supply.
not work ∙ See "Changing the bulb".
20
W / 220- - - - 240 V~ W / 220 W / 220 240 V~ 240 V~ 240 V~