Troubleshooting - Electrolux ZUCA1 User Manual

Hide thumbs Also See for ZUCA1:
Table of Contents

Advertisement

D
DISHWASHER DOES NOT WASH
WELL
GLASSES AND DISHES ARE
NOT DRIED PROPERLY
CONDENSATION ON GLASSES
STAINS ON THE GLASSES
EXCESSIVE FOAM IN THE TANK
SMEARS OR SPOTS ON THE
GLASSES
THE WASH OR RINSE ARMS
TURN SLOWLY
16

TROUBLESHOOTING

1. Check if the suction filter is dirty and clean it thoroughly.
2. Check if the wash jets are clogged by solid food remains.
3. Check that the initial amount of detergent or subsequent additions are
correct.
4. The selected wash cycle is too short. Repeat the cycle.
5. Check that the dishes are stacked correctly in the racks.
1. Check the instructions for the amount of rinse-aid.
2. Check that there is rinse-aid in the container and if necessary top up.
3. Check the set amount of rinse-aid.
1. Check that there is rinse-aid in the container and if necessary top up.
2. Check the set amount of rinse-aid.
3. Remove the rack of glasses immediately the cycle has ended.
1. Only use "non-foaming" products for professional dishwashers.
1. Check if the amount of product dispensed by the detergent dispenser is
excessive.
2. Ensure that the tank has not been cleaned with unsuitable cleaners.
Drain the tank and rinse thoroughly before new wash cycles.
3. If a foaming detergent has been used, drain and refill the tank with
water until the foam disappears.
1. Reduce the amount of rinse-aid.
1. Remove and thoroughly clean the arms.
2. Clean the wash pump suction filter.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zuca3Fuca3ddNuca1ddgNuc1gmsNuc1Euc1 ... Show all

Table of Contents