Sauder Harbor View 417586 Manual page 20

Step 14
Lay the remaining BACK (K) over DOOR ENDS (A and B),
å
and BRACE (L).
Make equal margins along all three edges of the
å
BACK (K). Push on opposite corners of your unit if needed
to make it "square".
Fasten the BACK (K) to your unit using the NAILS (1N).
å
NOTE: Perforations have been provided for access
å
through the BACK. Carefully cut out the rectangle in the
BACK for proper ventilation of your CPU.
Page 20
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
K
417586
Caution
Edge without holes
NAIL
(15 used in this step)
www.sauder.com/service
1N