Brave BRM500 Operation And Service Manual page 31

BRAVE
máquina continua de solución de problemas
Pump motor will
not start (motor
hums)
Pump motor starts
slow or overheats
and stops
Pump motor stops
and will not start
Low voltage
Machine shocks
operator
Specifications
28
Pump frozen.
Defective motor.
Defective water pump.
Excessive back pressure.
Low voltage
Excessive back pressure.
Defective motor.
Motor starter "kicked out"
(if so equipped) or thermal
overload tripped.
Excessive back pressure.
Defective motor.
Incoming voltage incorrect. Have a qualified technician
Not large enough
extension cord.
Too long extension cord.
Machine improperly
grounded.
Outlet not grounded
800-350-8739
Machine must be thoroughly
warmed to above freezing.
Call service technician or take
motor to Repair/Warranty station.
See PUMP SERVICE.
See "Excessive back pressure"
above.
See "Low voltage" below.
See "Excessive back pressure"
above.
Call service technician, or take
motor to Repair/Warranty station.
Turn motor starter off to reset,
then turn on, or push thermal
overload reset button on motor.
See "Excessive back pressure"
above.
Call service technician, or take
motor to Repair/Warranty station.
check the motor terminal voltage.
Correct voltage is in MODEL
SPECIFICATIONS.
Use an extension cord with
amperes of watts rating as high as
or higher than that or the MODEL
SPECIFICATIONS.
Shorten extension cord.
STOP operating machine. Call
service technician.
Have properly wired outlet
installed.
www.braveproducts.com