Table of Contents
Advertisement
BRAVE
♦
CHEMICAL BALL VALVE:
tank. Turn 3 way valve handle to the "up chemical tank position "opening the chemical tank.
♦
CHEMICAL:
label instructions. Use necessary safety precautions.
♦
SPRAY TIP:
START-UP
1.
Remove the nozzle.
2.
Turn 3 way valve handle to the "up chemical tank position" opening the chemical tank.
3.
With the gun assembly in hand and trigger in "open" position flip the toggle switch to the
'on' position.
4.
Open and close the trigger until there is steady flow from the wand to remove air in the line.
This will take 1 – 2 minutes.
5.
Flip the toggle switch to the 'off' position.
6.
Replace the nozzle.
7.
For most effective sanitizing – disinfecting, keep nozzle from 8 to 24 inches away from the
cleaning surface.
NOTE:
If you have not used all the chemical leave the ball valve handle to the "down fresh water"
position. This will shut off supply of the chemical to the pump and allow flushing of the system with
fresh water.
CAUTION:
Do not operate the machine with empty chemical tank.
CAUTION:
You need flush the pump after each use to prevent chemicals from damaging pump
components.
Specifications
12
Check the position of the 3 way ball valve on the outlet of the
Mix chemical solution per chemical manufacturer instructions. Mix chemicals per
Use the supplied nozzle to perform the job.
800-350-8739
www.braveproducts.com
Advertisement
Table of Contents
