Snap-On TECHANGLE Manual page 9

00
100.0
FT-LB
M
Target Screen
Target Presets (PSET)
PSET function gives user ability to configure 10 preset target torque or target angle settings, each
with a minimum (target), maximum (over range) and batch count value. PSETs are stored in non-
volatile memory so that they are retained while power is off.
Adding a Torque Preset
1. From target torque screen, select units of measure.
2. Press and hold UNITS
3. ADD PRESET confirmation screen is displayed. Highlight
 buttons then press ENTER

a PSET.
4. MINIMUM TORQUE is target value at which green progress lights, audible alert and vibrator turn
on. Initial MINIMUM TORQUE value is value from target torque screen. MINIMUM TORQUE can
be set to any value within wrench torque range by pressing UP
desired target torque value has been set, press ENTER
5. MAXIMUM TORQUE screen is displayed next. MAXIMUM TORQUE is torque value above which
red progress lights turn on. Initial MAXIMUM TORQUE value will be MINIMUM TORQUE plus 4%.
Maximum torque value can be set greater than MINIMUM TORQUE value to 10% above wrench
maximum range by pressing UP

ENTER button.

6. BATCH COUNT screen is displayed next. Default value is zero. Batch count range is 0 to 99. Press
UP  /DOWN

time target torque is reached if a batch count of zero is entered. Mode Count decrements if a
non-zero batch count is entered and resets to batch count value when count reaches zero. Once
desired value has been set, press ENTER
7. PSET target screen is displayed labeled with next available PSET number from 01 to 10.
8. To enter additional torque presets, repeatedly press ENTER
is displayed and repeat steps above.
00
100.0
FT-LB
Target Torque Screen
ENTER button
PSET 01 03
100.0
FT-LB
Preset Torque Screen
ENTER
EXIT
button
SET HEAD LENGTH
held
SHOW DATA
CLEAR DATA
M
UP/DOWN buttons
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
CYCLE COUNT
M
U button for 3 seconds.

button.



 buttons to increment/decrement batch count. Mode Count increments each

UNIT
ADD PRESET
button
held
YES
NO
UP/DOWN buttons
ADD PRESET
YES
NO
CYCLES: 12
CLEAR
EXIT
M
UP/DOWN buttons
CYCLES: 12
ENTER
button
CLEAR
EXIT
M
NO menu selection returns to main menu without adding

/DOWN buttons. Once desired value has been set, press



button.

UP/DOWN buttons
ENTER
button
MINIMUM TORQUE
100.0
ENTER button
8
CYCLES: 0
ENTER
button
CLEAR
EXIT
M
SET HEAD LENGTH
ENTER
button SHOW DATA
CLEAR DATA
CYCLE COUNT
M
YES menu selection using UP
/DOWN


button.


button until target torque screen

ENTER
button
MAXIMUM TORQUE
104.0
FT-LB
BATCH COUNT
3
ENTER button
 /DOWN

buttons. Once


UP/DOWN buttons
FT-LB
ENTER
button
UP/DOWN buttons