Troubleshooting - Snap-On TECHANGLE Manual

Note: Calibration interval is calculated from either In-Service Date or last Calibration date (see SHOW
INFO menu) depending on which is more recent date. When clock Date is greater than In-
Service or Last Calibration date, plus Cal Interval, "CAL NEEDED" message will be displayed on
power up and after a re-zero. Pressing ENTER
torque while "CAL NEEDED" message is displayed will immediately display torque or angle
measurement and return to target menu when released.
Note: As an alternative to calibration interval, a Calibration Cycle Counter is provided in Calibration
menu (Contact your local Snap-on Repair Center regarding Calibration menu).

Troubleshooting


Note: If any of following issues persist, return wrench to an authorized Snap-on repair center.
Issue
Wrench does not turn on
POWER
when
pressed
Torque reading out of spec
Wrench did not retain settings
while batteries were removed
Torque or angle displayed
while no torque applied
Possible Cause
Dead/No batteries
q
button
Software glitch
Calibration required
Incorrect head length entered Enter correct offset head length
Batteries removed before
settings were saved in non-
volatile memory.
Torque or angle zeroed while
torque applied
Low battery
Dead battery
Torque applied while zeroing
Wrench over torqued
Wrench improperly calibrated Recalibrate
Torque sensor failure
Wrench moving during
zeroing
Gyro unstable
POWER
during angle zeroing (Aborted
zeroing to access menus)
Over 125% of full scale torque
applied
Wrench rotated too fast
during angle measurement

button will continue to target menu. Applying

q
button pressed
19
Resolution
Replace batteries
Cycle power using end-cap
Recalibrate
Clear data, re-enter settings and
POWER
press and hold
button to power down wrench
before removing batteries
Place wrench on stable surface
with no torque applied and
POWER q
press button to re-
zero wrench

ENTER
Press button to

continue using wrench and
replace batteries soon
POWER q
Press button to turn
off wrench and replace batteries
Remove torque and re-zero
Recalibrate
Return to Snap-on Repair Center
Place wrench on stable surface
Return to Snap-on Repair Center
Place wrench on stable surface
POWER q
and press
re-zero
POWER
Cycle power using
button and recalibrate
Place wrench on stable surface
POWER q
and press
re-zero
q
button to
q
button to