Set Date/Time - Snap-On TECHANGLE Manual

00
100.0
FT-LB
UP/DOWN buttons
Note: UNITS
Note: Torque THEN Angle Presets are entered by pressing and holding Units button while on
Torque THEN Angle screen. Refer to "Adding a Torque Preset" and "Adding an Angle
Preset" in Basic section for parameter entry.
Note: Torque cycle is not recorded in memory unless both torque and angle reach targets.
Note: Red and yellow progress lights turn on if torque exceeds 110% of wrench full scale or if
angle exceeds target plus 4% in manual mode.
Note: Red and yellow progress lights turn on if torque exceeds maximum torque or if angle
exceeds maximum angle in Preset mode.
Calibration
Calibration menu is password protected. Contact your local Snap-on
Repair Center regarding Calibration menu.
Setting Date and Time
Set Date/Time function allows user to set real-time-clock date and time for time stamping data
records, recording last calibration date and notifying user of an expired calibration interval.
Note: When date and time is set for first time, In-Service date is also set and is used for calculating
initial calibration interval (see "Setting Calibration Interval" in Advanced Configuration
section).
1. From Configure menu, use UP

press ENTER button.

2. SET DATE screen is displayed with year highlighted.
3. Use UP  /DOWN

4. Use UP /DOWN


5. Use UP  /DOWN

6. SET TIME screen is displayed with Hour highlighted.
7. Use UP  /DOWN

8. Use UP /DOWN


9. Use UP  /DOWN

10. Clock is set and Configure menu is displayed.
ENTER
button
45
DEG
UP/DOWN buttons
U button can be used to select torque units while on Torque THEN Angle screen.
/DOWN


 buttons to set year then press ENTER
buttons to set month then press ENTER

 buttons to set day then press ENTER
 buttons to set hour then press ENTER
buttons to set minutes then press ENTER

 buttons to set seconds then press ENTER
00
ENTER
button
TQ: 100.0 FT-LB
THEN AN: 45 DEG
Torque THEN Angle Screen
buttons to highlight

17
00
EXIT
MODE SETUP
CALIBRATION

SET DATE/TIME

SET DATE/TIME

button to highlight month.


button to highlight day.


button.


button to highlight minutes.


button to highlight seconds.


button.

selection then