Speakers; Removing The Speaker - Dell Latitude 7410 Service Manual

Steps
1. Align and place the display assembly at an convenient angle and replace the two M2.5x4 screws securing the hinges of the display
assembly to the palmrest.
2. Connect the eDP cable, camera cable and touch sensor cable to the system board.
NOTE: The display cable and sensor daughter board cable are bundled together with tape. Connect the display cable
first followed by sensor daughter board cable.
3. Replace the eDP bracket on the eDP connector on the system board and replace the two M2x2 screws securing it to the system
board.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Install the:
a. Base cover
2. Follow the procedure in

Speakers

Removing the speaker

Prerequisites
1. Follow the procedure in
2. Remove the:
a. Base cover
b. Battery
3. Disconnect the WWAN antennae
About this task
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
After working inside your computer.
Before working inside your
cables.
computer.
Removing and installing components 33