Steps
1. Install the palmrest antenna into its slot on the palmrest assembly.
2. Route the antenna cables from underneath the system board along the routing channel.
3. Replace the two M2x2.5 screws securing the palmrest antenna to the palmrest assembly.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Install the:
a.
WLAN antenna bracket
b.
Base cover
2. Follow the procedure in
Heatsink assembly
Removing the heatsink assembly
Prerequisites
1. Follow the procedure in
2. Loosen and remove the M2x2 screw on the
3. Remove the:
a.
Base cover
About this task
The following images indicate the location of the heatsink assembly and provide a visual representation of the removal procedure.
28
Removing and installing components
After working inside your
computer.
Before working inside your
SSD thermal plate
computer.