Dell Latitude 7410 Service Manual page 46

Steps
1. Align the screw holes on the keyboard support bracket with that on the keyboard and replace the two M2x2 screws.
2. Align the and place the keyboard into its slot in the palmrest assembly.
3. Replace all the M1.6x2 screws securing the keyboard to the palmrest assembly.
Depending on the configuration the number of screws vary :
• Aluminum palmrest: 26
• Carbon Fiber palmrest: 19
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
1. Install the:
a. System board
b. I/O board
c. Heatsink assembly
d. WLAN antennae bracket
e. Battery
f. Base cover
2. Follow the procedure in
46 Removing and installing components
After working inside your computer.