Installation Instructions; Safety Instructions - Loewe WM 54 Installation Instructions Manual

Installation instructions

Wall holder WM54, Connect 37/ 42
Wall holder WM56, Connect 32

Safety Instructions

Loewe will accept no liability for damages caused by
improper installation.
Install your set so that it cannot be damaged, for example, by
children playing and does not pose a danger to them either.
Lay the connecting cables so that there is no danger of
tripping over them.
The wall holder (and suitable adapter) are only designed for
rails) of the TV hung on the wall. There is a danger of
crushing.
In addition, the safety instructions for our TVs also apply
here.
Assembly
The load capacity of the wall and the fastening of the wall
mount are your responsibility.
Because of the wide variety of building materials for walls
and the di erent types of fastenings for them, we have not
enclosed any fastening material with the TV set.
Procure suitable fastening material for your wall from your
dealer.
Ask a building expert if in doubt.
Make sure there are no cables / pipes in the area of the holes.
See the sketches 1 to 3.
Sketch 1: Scope of delivery - without Allen Wrench
Sketch 2: Preparing the TV sett
Sketch 3: Wall mounting
must be 333 mm for the Connect 32 TV set and 533 mm for the
Connect 37 TV set and 543 mm for the Connect 42 TV set.
TV set, remove foot, mount spacer
Pull the mains plug out of the power socket before handling the TV.
Lay a piece of felt or a soft blanket down where you want to put
down the TV set. This protects it from being damaged.
Place the TV set screen down on the prepared surface so that the
foot of the TV protrudes just over the protective underlay (felt,
blanket).
Loosen and remove the 3 screws (sketch 2, arrows C) with a scre-
wdriver.
Pull the foot o the TV in the direction of the arrow (sketch 2).
ed personnel.
Remove the protective foil from the adhesive areas of the two
spacers (sketch 2, arrow D).
Stick the two spacers (sketch 2, arrow D) onto the rear panel as
illustrated.
Connect the plug to the TV set
les (mounting
Hanging in and tilting the TV set in the wall holder
Depending on the type of set, your TV can weigh up to about 30kg.
Ask someone to help you hang in the TV set.
To hang in, hold the TV set tilted back about 30° at the top (see
sketch 3).
Hang the TV set into the hooks (sketch 4, arrows).
It can only be removed (unhooked from the hooks of the wall hol-
der) when the TV set is pulled away from the wall at the bottom by
about 30°.
Your TV set can be tilted to several positions on the wall mount.
You can select the tilt of the TV screen with 0° (TV set hanging
vertically on the wall), 2.0° (TV set hanging on the wall tilted slightly
forward) and 4° (TV set hanging on the wall tilted slightly further
forward).
push forward (back) at the top.
You can select the catch and thus the angle as you wish.
les