Page 11
CV620-IP / CV620-NDI RS-232 Command Set Camera Block Inquiry Command List Byte Comments Byte Comments 19.1 Lens Control System Inquiry Command. Command Set 8x 09 7E 7E 00 FF Byte Comments Focus Position (HH) Byte Comments Byte8 Source Address Byte12...
Page 12
CV620-IP / CV620-NDI RS-232 Command Set 19.2 Lens Control System Inquiry Commands. Command Set 8x 09 7E 7E 01 FF Byte Comments Byte Comments Byte Comments Gain Position Byte Comments Exposure Mode Source Address Byte12 Byte8 B Gain (H) Byte0...
Page 13
CV620-IP / CV620-NDI RS-232 Command Set 19.3 Lens Control System Inquiry Commands...Command Set 8x 09 7E 7E 02 FF Byte Comments Byte Comments Byte Comments 0 1: 1/50, 1/25 0: 1/60, 1/30 Byte Comments Camera ID (HH) ICR 1: Provided 0: Not...
Page 14
CV620-IP / CV620-NDI RS-232 Command Set 19. 4Lens Control System Inquiry Commands…..Command Set 8x 09 7E 7E 03 FF Byte Comments Byte Comments Byte Comments Byte Comments Source Address Byte8 Byte12 Byte0 Byte4 Destination Address Byte Comments 2DNR Level High Sensitivity mode (1: ON,...
Page 15
CV620-IP / CV620-NDI RS-232 Command Set 19.5 Lens Control System Inquiry Commands…..Command Set 8x 09 7E 7E 04 FF Byte Comments Byte Comments Byte Comments Byte Comments Source Address Byte8 Byte12 Byte4 Byte0 Destination Address Byte Comments Byte13 Byte5 Byte9...
Page 16
CV620-IP / CV620-NDI RS-232 Command Set 19.6 Lens Control System Inquiry Commands…..Command Set 8x 09 7E 7E 05 FF Byte Comments Byte Comments Byte Comments Byte Comments Reserved Reserved Source Address Reserved Byte8 Byte12 Byte0 Byte4 Destination Address Byte Comments...
CV620-IP / CV620-NDI RS-232 Command Set RS232 over IP 20.1 Overview of RS232 over IP RS232 over IP allows you to control this unit from the controller with the IP communication function via the LAN by using RS232. You can connect up to 5 controllers simultaneously on one LAN segment.
Page 18
CV620-IP / CV620-NDI RS-232 Command Set 21.2 VISCA command This is a command from the controller to the peripheral device. When the peripheral device receives this command, Acknowledge is returned. After completing command processing, a completion notice is returned. This command uses the socket of VISCA. The order of completion notices may be changed if the multiple commands are sent to the same peripheral device.
CV620-IP / CV620-NDI RS-232 Command Set 21.12 Sequence Number The controller stores the sequence number that is added every time a message is sent. If the sequence number reaches the limit, next values will be 0. The peripheral device saves the sequence number in the message from the controller, and stores the sequence number of the received message corresponding to the message sent to the controller.
CV620-IP / CV620-NDI RS-232 Command Set 21.14 Delivery confirmation PelcoD Internal Command List Internal Byte 2 Byte VISCA over IP uses UDP as a communications protocol of the transport layer. Delivery of messages Byte 1 Byte 4 Byte 5 Byte 6...
Need help?
Do you have a question about the CV620-IP and is the answer not in the manual?
Questions and answers