Table of Contents
Advertisement
INTRODUCTION
Parts Check List
To purchase replacement battery
1. Handset
packs, call VTECH Communications
2. Base Unit
at 1-800-595-951 1. In Canada, call
3. Wall mounting bracket
VTECH Electronics at 1-800-267-
4. AC power adapter
7377.
5. Belt clip
6. Battery pack
7. Telephone line cord
HANDSET
n
BASE UNIT
AC POWER ADAPTER
6 - 3 B
TELEPHONE LINE CORD
WALL MOUNTING
BRACKET
BELT CLIP
BATERY PACK
FCC and IC Regulations
This equipment complies with Parts 15
and 68 of the Federal Communications
Commission (FCC) rules for the United
States. It also complies with regula-
tions RSS210 and CS-03 of lndustry
and Science Canada. Operation is
subject to the following two conditions:
(1) this device may not cause interfer-
ence, and (2) this device must accept
any interference, including interfer-
ence that may cause undesired opera-
tion of the device.
A label is located on the underside of
the base unit containing either the FCC
registration number and Ringer Equiva-
lence Number (REN) or the lndustry
Canda (IC) registration number and
Load Number. You must, upon re-
quest, prov.ide this information to your
local telephone company.
This equipment is compatible with
inductively coupled hearing aids.
Should you experience trouble with this
telephone equipment, please contact:
VTECH COMMUNICATIONS
SERVICE DEPT. at 1-800-595-951 1.
In Canada, call VTECH Electronics at
1-800-267-7377.
For repairlwarranty information. The
telephone company may ask you to
disconnect this equipment from the line
network until the problem has been
corrected.
FCC Part 15
Warning: Changes or modifications to
this unit not expressly approved by the
party responsible for compliance's
could void the user's authority to
operate the equipment.
The equipment has been tested and
found to comply with part 15 of the FCC
rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment gener-
ates, uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the
instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try and correct the interference by one
or more of the following measures:
-
Reorient or relocate the receiving
antenna.
-
Increase the separation between
the equipment and receiver.
-
Connect the equipment into an
outlet or on a circuit different from
that to which the receiver is con-
nected.
-
Consult the dealer or an experi-
enced radio/TV technician for help.
Advertisement
Table of Contents
