Wall Mounting - VTech VT1940 Instruction Manual

GETTING STARTED
WALL MOUNTING
Check for a dial tone. After the
battery pack is charged, rotate the
Base Unit antenna to an upright
position. Pick up the Handset and
press(^).
You will hear a dial
tone. If not, see 'IN CASE OF
DIFFICULTY'.
Fill in the telephone number card on
the base unit.
FILL IN THE
TELEPHONE
NUMBER CARD
CAUTION:
1. Never install telephone wiring
during a lightning storm.
2. Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3. Never touch uninsulated telephone
wires or terminals unless the
telephone line
,
has been
disconnected at the network
interface.
4. Use caution when installing or
modifying telephone lines.
The Wall Mounting bracket is designed
to fit on standard Wall Mounting plates.
1. Choose a spot near an electrical
.*
outlet and a telephone jack.
Your phone requires a modular
telephone jack and a standard
electrical outlet (120v AC). The
e
power cord is six feet long; make
sure there is an electrical outlet
within reach of the base. The
outlet should not be controlled by
a wall switch. If the switch is ever
turned off, the phone will not
operate.
2. Position the wall mounting
bracket on the base.
Line up the tabs on the wall
mounting adapter with the holes
on the bottom of the base (Figure
1). Snap the wall mounting bracket
firmly in place.
Mount the base on the wall.
Position the base so the mounting
studs will fit into the holes on the
bottom of the base. Position the
power cord to extend down the
wall the phone is to be mounted
o'n. Slide the base down on the
mounting studs until it locks into
place.
Figure 1
5. Plug the AC adapter into an
electrical outlet and the DC
connecter into the power jack
located on the back of the Base
Unit
.
(Figure 2)
Figure 2
4. Connect the telephone line cord.
The telephone line cord has a
snap-in plug at each end. Insert
one of the plugs into the jack on
the back of the base. Insert the
other end of the plug into the wall
jack.