Operation - Intex SimpleSpa SB-B10 Owner's Manual

SPA CONTROL UNIT PANEL
F
G
E
D
On/Off Button:
buttons. The light next to the button is green when activated. Press this button to turn off all
currently activated functions.
NOTE: The On/Off button may appear as a black button in the center of the control panel.
Heat Button:
until the water temperature reaches the set temperature. When the spa water temperature drops
1.8-3.6°F (1-2°C) below the set temperature the heating system will restart. When the flame icon
on the display is red, the heating system is activated. When the flame icon turns green, the water
is at the set temperature. The heating system is at rest and the filtration system will continue
working nonstop.
NOTE: To stop the filtration system while the heater is at rest mode, press the flame button first
and then the filter button. Pressing the flame button only while the heater is at rest mode will turn
off the heating system only and the filtration system will operate for another 24 hours before it
turns off automatically.
IMPORTANT: The following conditions will lead to slow water heating.
• The ambient temperature is lower than 50ºF (10ºC).
• Outdoor wind speed is above 3.5-5.4 m/s (8-12 mph).
• The air bubble function is activated when heating the spa water.
• The spa is not properly covered with the spa cover when the water is heating.
Celsius/Fahrenheit Toggle button:
The temperature can be displayed in either Fahrenheit or Celsius. The system's default is
Celsius.
NOTE: The default temperature is 68°F (20°C). Temperature adjustment ranges from 68°F
(20°C ) to 104°F(40°C).
Temperature Adjustment Buttons:
will cause the LED to flash. When flashing you can adjust to the desired temperature setting. If
you hold these buttons down the values will rapidly increase or decrease. The new and desired
temperature setting will remain on the LED display for 5 seconds to confirm the new value.
Water Filter Button:
This button turns the filter pump on and off. If the heating system is activated the filtration system
will automatically start.
The water filter icon on the display is green when activated.
Bubble Button:
auto-shutoff feature. The bubble icon on the displays is green when activated.
CAUTION: Do not run Bubble system when the cover is attached, air can accumulate inside the
spa and cause irreparable damage and bodily harm.
40
o C
LED Display:
NEVER use the spa if indicated water temperature is more than 40°C (104ºF).
S AVE THESE INSTRUCTIONS

OPERATION

Once the unit is plugged in, use this button to active the control unit panel
Use this button to activate the heating system. The pump will heat the spa water
Pressing the Temperature Increase or Decrease buttons
Use this button to activate the massage system, which has a 30-minute
Once plugged in the LED displays the current water temperature automatically.
WARNING
(348PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 10/25/2019
A: Heat Button
A
B: Celsius/Fahrenheit Toggle Button
C: Temperature Increase Button
B
D: Temperature Decrease Button
H
E: Water Filter Button
F: Bubble Button
C
G: LED Display
H: On/Off Button
348
English
PO
Page 13