Table of Contents
Advertisement
MEMORY DIALING
Press PHONE , the number on the
display will be dialed after a 2 second
pause.
NOTE:
The ability to temporarily add
memory contents to digits already
entered on the display operates in
the same way for CID and speed dial
memories.
In this way, long distance and area
codes (for example, 1503) can be
entered on the LCD and can preface
numbers recalled from CID memory
before dialing. This is important
because only the last 7 digits of any
number are displayed when dialing
from CID memory.
Changing Stored Numbers
To change or replace a stored number
simply enter the new number on the
display and store it in the memory
location you wish to change.
Deleting Stored Numbers
•
Press MEM . The display will
c h a n g e t o " S P E E D D I A L
LOCATION_ _".
•
Enter memory location number
(01-20).
•
Press CLR/DEL . The display will
change to "LOCATION XX
DELETED".
•
Press OFF to exit.
NOTE:
Stored numbers are retained in
memory even if the Base loses its
power or the Handset battery is
removed.
Storing Special Codes
To insert a pause in a phone number,
press HOLD at the appropriate point
when entering the number on the LCD.
This inserts a 2 second pause. A
" P " appears in the display to show the
pause. For longer pauses, press HOLD
two or more times. Each press makes
the pause 2 seconds longer and is
treated as a stored digit.
If your phone is connected to a PBX,
you can store the PBX access number
and a pause before the phone number.
For example, to store 9-PAUSE-555-
1234 in memory location 08, do the
following:
1. Press
9
2. Press HOLD
3. Dial 5551234
4. Press PROG
5. Enter 08
26
Advertisement
Table of Contents
