Basic Operation; Telephone Operation; Handset Operation - VTech t2415 User Manual

Telephone Operation

Handset Operation

Answer a Call
Press any key
except OFF.
Hold
Press to put a call
on hold. Press again
to release hold.
-OR-
Lift the Handset of
an extension.
Make a Call
Press PHONE, then dial
the number.
-OR-
Dial the number (use
to backspace and
correct digits), then
press PHONE to call.
Flash/Call Waiting
If you have Call Waiting
service, a beep will sound
when someone calls while
you're on a call. Press
PHONE/FLASH to put the
current call on hold and take
the new call. Press this
button at any time to switch
back and forth between
calls.
Channel
Switch to a clear channel
while on a call.
Delete
While Handset is in idle mode,
press and hold to delete all
records in the Call Log.
When viewing the Call Log,
press to delete the current
record displayed.
Redial
Press PHONE, then press
REDIAL/PAUSE to call the last
number dialed.
-OR-
Press REDIAL/PAUSE, then
press PHONE to call the last
number dialed.
Press REDIAL/PAUSE twice to
delete the last number dialed.
Pause
Program
Press REDIAL/PAUSE to inset
Enter programming
a pause when entering num-
mode with Handset
bers.
idle (on hook).
7
Handset Volume
Adjust the volume while
on a call. A double beep
will sound when you
reach the maximum or
minimum setting.
Select
Use SEL in conjunction
with PROG during
Handset programming.
End a Call
Press OFF.
-OR-
Place Handset
in its Base.
Exit
programming
Cancel a Page