Getting Started; Installation; Before You Install - VTech t2415 User Manual

Cordless telephone system with caller id

Hide thumbs Also See for t2415:

Table of Contents

1. Choose a location for the Base near an electrical outlet and a telephone

jack. This phone requires a modular telephone jack and a standard

electrical outlet (110V AC) not controlled by a wall switch.

2. Install the Handset battery. Use only VTech batteries.

3. Attach the Belt Clip to the Handset (optional).

To Attatch

NOTE: Install the Base Unit away from electronic equipment, such as personal

computers, television sets or microwave ovens. Avoid excessive heat, cold, dust

or moisture.

a) Remove battery

compartment cover by

pressing on the indentation

and sliding downward.

b) Align the two holes in the plug with the

socket pins, then snap the plug into place.

c) Place the battery in the compartment

with the wires in the lower right corner.

Angle the top of the battery under the top

claws first, then snap the bottom of the

pack in. Place the wires under the guide,

located below the battery.

d) Replace the battery compartment cover.

To Remove

Table of Contents

Need help?

Do you have a question about the t2415 and is the answer not in the manual?