Section 1 - General Information; Contacting Aquacal Autopilot; Safety - Aquacal AutoPilot WS03 Operation And Installation Manual

SECTION 1 - GENERAL INFORMATION

1.1 Contacting AquaCal AutoPilot

Web www.AquaCal.com
(727) 823-5642
Phone
8-5 pm, Eastern M-F
Fax (727) 821-7471
Please have your model and serial numbers available when contacting AquaCal AutoPilot for questions,
service, or parts.

1.2 Safety

For personal safety, and to avoid damage to equipment, follow all safety instructions displayed on the
equipment and within this manual. Repair and service of your heat pump must be performed by qualified
service personnel. Should you suspect your equipment is not performing properly, refer to the section in
this manual entitled: "Troubleshooting," to determine if a call for service is required. Warranties will be
voided if the equipment has been improperly installed, maintained or serviced. Throughout this manual,
safety signals have been placed where particular attention is required.
Safety Signals:
" WARNING" - signal relates to personal safety.
CAUTION" - signal promotes avoiding damage to the equipment.
"
Follow all National Electric Codes (NEC) unless State or Local guidelines supersede. When installing and
using your heat pump, basic safety precautions must always be followed, including the following:
WARNING - Failure to heed the following may result in injury or death.
 Repairs must be performed by a qualified technician. If service is deemed necessary, contact
installing dealer or AquaCal AutoPilot Customer Support for a service center in your area.
 Heat pump contains refrigerant under pressure. Repairs to the refrigerant circuit must not be
attempted by untrained and/or unqualified individuals. Service must be performed only by qualified
HVAC technicians. Recover refrigerant before opening system.
 Improper water chemistry can present a serious health hazard. To avoid possible hazards, maintain
pool / spa water per standards detailed later in this manual.
CAUTION - Failure to heed the following may result in equipment damage.
 Maintain proper water chemistry in order to avoid damage to pump, filter, pool shell, etc.
 Do not use glue on the threaded portion of the equipment's unions. A glued-in-place union will
prevent the equipment from being properly winterized.
SAVE THESE INSTRUCTIONS
Page 1