Electrical Cutouts; Placing Heat Pump; Positioning Clearances - Aquacal AutoPilot WS03 Operation And Installation Manual

Water source
Hide thumbs Also See for AutoPilot WS03:
Table of Contents

Advertisement

4.1.d Electrical Cutouts
1-3/8 in [3.5 cm]
7/8 in [2.2 cm]
1-3/8 in
[3.5 cm]

4.2 Placing Heat Pump

4.2.a Positioning Clearances
 Confirm adequate clearance is provided above and around heat pump to permit access panel
removal during equipment maintenance and service. Do not place objects such as shrubs, bushes,
lawn furniture, chemical containers, etc. immediately adjacent or on top of heat pump. These items
can prevent access and may result in damage to the heat pump.
 The unit should be located at least 18 inches from any wall and at least 18 inches between units to
permit rear plumbing and electrical connections.
 Follow all applicable local, state, and national requirements relative to spacing from other objects or
equipment.
WS03, WS05 and SP05
BOTTOM
WS10
BOTTOM
Page 13
Figure 10
Figure 11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Autopilot ws05Autopilot ws10Autopilot sp05

Table of Contents