Table of Contents
Advertisement
Page 28
CAUTION
- Failure to heed the following may result in equipment damage.
Service Level Programming must only be attempted by authorized service centers.
The time delay should only be de-activated for diagnostic convenience, and must be
Using the back door entry to access a locked keypad will reset all settings to factory
4.5.a Program Displays
MESSAGE
"CFI"
"ULC"
"ELC"
"LOC"
"FS2"
"JAO"
"dEL"
"tSC"
"dSC"
"dBS"
"dBP"
4.5.b Service Level Programs
STEPS
Entering Service Menu
Press and hold "Up" and
"Down" buttons simultaneously.
Press "Pool / Spa" button until
"LOC" is displayed.
Use "Up" or "Down" button to
enter factory access passcode.
Press the "Pool / Spa" button
once.
Deactivating Time Delay
The time delay should only be de-activated by qualified HVAC technicians for diagnostic convenience, and must be re-
activated prior to placing heat pump back in service. Failure to reset time delay feature could result in permanent
damage to heat pump compressor.
Enter Service Menu
Press the "Pool / Spa" button
until "dEL" is displayed.
If adjustments are deemed necessary, contact installing dealer or AquaCal AutoPilot
Customer Support. Un-authorized adjustments in the Service Menu (beyond the
"LOC" menu) will void factory warranty.
re-activated prior to placing heat pump back in service. Failure to reset time delay
could result in permanent damage to the heat pump compressor.
default including any installer entered configuration. See section entitled "Resetting
Heat Pump ("Back Door" Entry)" on page 31 for more information. Re-programming
all custom site condition settings will be required when using this reset.
Select water temperature format; in either Celsius or Fahrenheit.
Enable heat pump lock-out feature.
Select password to lock heat pump access.
Access to site-dependent setup parameters. Factory code required. (Not intended for use
by the owner)
Configure remote flow switch or automatic thermostat switch connected to heat pump.
Configure an external controller connected to the heat pump.
Deactivate time delay.
Calibrate water sensor.
Calibrate defrost sensor.
Adjust number of degrees water temperature must fall below set point before spa
thermostat closes and calls for heat or cooling. (Dead-Band Spa)
Adjust number of degrees water temperature must fall below set point before pool
thermostat closes and calls for heat or cooling. (Dead-Band Pool)
"CF1" code appears.
This is the entrance point for the Service Menu.
The factory default code is "0".
Service level programs are now available. If left idle for 15 seconds, program will
time-out and exit programming mode.
If needed, see "Entering Service Menu" in this chart.
This is the entrance point for the Time Delay Menu.
DESCRIPTION
EXPLANATION
Advertisement
Table of Contents
