Removing The Snow Blade - Toro 79252 Operator's Manual

Installation
2
1
Figure 11
1. Lift arm
8. Set Dial-a-Height to the Mounting Position, and
lower attachment lift all the way; refer to Setting
Height-of-Cut.
9. Position lift plate notch around left side lift rod
and slide lift plate onto attachment lift arm
(Fig. 12). Secure with hairpin cotter at lift arm.
10. Connect lift rod trunnion at one of the holes in
the attachment lift plate with 5/8" washer and
hairpin cotter (Fig. 12).
Note: Low hole provides maximum blade
lift, but requires the greatest lift effort.
Top hole requires less lift effort, but
has lower lift height.
4
2
5
Figure 12
1. Notch
2. Lift plate
3. Lift arm
8
1246a
2. Front hitch
1
6
3
6
1265
4. Lift rod trunnion
5. Washer 5/8"
6. Hairpin cotter

Removing the Snow Blade

Note: Save all hardware, rods, washers and
hairpin cotters for reuse when
installing blade.
1. Park the machine on a level surface, disengage
the power take off (PTO), set the parking brake,
and turn the ignition key to "OFF" to stop the
engine. Remove the key.
2. Raise attachment lift to the transport position .
Turn the Dial-a-Height knob counterclockwise,
all the way, and lower the attachment lift lever to
the mounting position; refer to Lowering
Attachments.
3. Remove hairpin cotter and 5/8" washer from
trunnion at lift plate (Fig. 13).
4. Remove hairpin cotter and slide lift plate off
attachment lift (Fig. 13).
3
4
2
Figure 13
1. Hairpin cotter
2. Washer 5/8"
1
1
1265
3. Trunnion
4. Lift plate