Toro 79252 Operator's Manual page 7

5. Attach index lever to frame bracket with 1/2 x 1"
bolt and 1/2" nut (Fig. 3).
IMPORTANT: Do not tighten nut and bolt
excessively to cause binding of lever at bracket.
6. Install eye bolt and eyelets with (2) #10 washers
and (2) #10 lock nuts(Fig. 3).
7. Thread jam nut and turnbuckle onto cable and
hook into handle lever(Fig. 3).
8. Route cable through eyebolt and eyelet and
attach Z end to back hole of index plate (Fig. 3).
9. Adjust turnbuckle so the index pin is pulled out
of channel when the release lever is squeezed,
for easy side-to-side movement (Fig. 3). Tighten
jam nut securely.
10. Attach one end of control rod to index lever with
1/2" washer and hairpin cotter. (Fig. 3).
1
7
Figure 3
1. Index lever
2. Bolt 1/2 x 1"
3. Nut 1/2"
4. Cable Z end
5. Eyelet
6. Eyebolt
7. Lock nut and washer #10
11. Insert control rod, end with welded washer, thru
hole in bottom plate of channel weldment
(Fig. 4). Secure with cotter pin, between the
plates.
8
4
11
10
6
5 4
9
3
2288
2 14 13 12
8. Handle lever
9. Back hole of index plate
10. Turnbuckle
11. Jam nut
12. Control rod
13. Washer 1/2"
14. Hairpin cotter
Figure 4
1. Control rod
2. Plate
12. Place front lift weldment between frame and
attach captured plate to frame with (2) 3/8 x 1"
bolts and (2) 3/8" lock nuts (Fig. 5).
13. Slide remaining plate over shaft and secure to
frame with (2) 3/8 x 1"bolts and (2) 3/8"lock
nuts. Secure lift assembly shaft to plate with
5/8" washer and cotter pin (Fig. 5).
14. Attach lift rod to lift weldment and secure with
5/8" washer and cotter pin (Fig. 5).
7
8
3
5
4
8
Figure 5
1. Lift weldment
2. Captured plate
3. Bolt 3/8 x 1"
4. Lock nut 3/8"
Installation
2
3
1
1467
3. Cotter pin
1
2
4
3
6
7
1246b
5. Plate
6. Lift rod
7. Washer 5/8"
8. Cotter pin
5