Assemble Blade - Toro 79252 Operator's Manual

Installation
Installation

Assemble Blade

1. Attach channel assemble and blade trip springs
to blade with rods and hairpin cotters and cotter
pins (Fig. 1).
2. Apply liberal amount of general purpose grease
to pivot area of frame and channel (Fig. 1) and
attach with 3/4 x 3/4" bolt and 3/4" nut.
IMPORTANT: Do not tighten nut and bolt
excessively to cause binding on channel
weldment as it pivots side-to-side.
2
8
3
4
1
7
Figure 1
1. Channel Assembly
2. Trip spring
3. Rod
4. Cotter pin
4
8
5
4
6
5
1469a
5. Grease here
6. Bolt 3/4 x 3/4"
7. Nut 3/4"
8. Hairpin cotter
3. Place index rod through hole in frame and slide
into hole in index pin (Fig. 2).
4. Hook index rod into front hole of index plate and
attach to frame with 3/8 x 1" bolt, 3/8" washer
and 3/8" lock nut (Fig. 2).
IMPORTANT: Do not tighten nut and bolt
excessively to cause binding of lever at bracket.
5
6
Figure 2
1. Index rod
2. Index pin
3. Front hole of index plate
4
3
1
2
2287
4. Bolt 3/8 x 1"
5. Washer 3/8"
6. Lock nut 3/8"