Table of Contents
Advertisement
Maintenance
Reversing the Scraper Blade
The scraper blade contacts the ground preventing
damage to the snow blade. Periodically inspect the
scraper blade for wear. When scraper becomes worn,
before working surface contacts the housing, reverse
the scraper blade.
1.
Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine. Remove the key.
2.
Raise the attachment lift lever: Refer to Raising
Attachments, and support the housing off the
ground.
3.
Remove lock nuts and carriage bolts to remove
scraper blade (Fig. 21).
4.
Reverse scraper blade to replace a worn edge and
install with previously removed hardware
(Fig. 21).
2
3
Figure 21
1. Lock nut
2. Carriage bolt
16
1468
1
3. Scraper blade
Storage
1.
Before long term storage wash the machine with
mild detergent and water to remove dirt and
grime from the entire machine.
2.
Check the condition of the scraper blade; refer to
Reversing Scraper Blade, page 16.
3.
Grease and oil the blade; refer to Greasing and
Lubrication, page 15.
4.
Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged or
defective.
5.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service
Dealer.
6.
Store the machine in a clean, dry garage or
storage area. Cover the machine to protect it and
keep it clean.
Advertisement
Table of Contents
