Securing Nuts And Bolts; Lubrication; Speed Change Cable - Hayter RANGER Owner's Handbook Manual

1.25

SECURING NUTS AND BOLTS

Regularly check that all securing nuts and bolts are tight.
Replace missing or damaged items immediately.

LUBRICATION

Lubricate the wheels, pivot points and linkages with engine
oil every 25 operating hours.
Apply a good quality medium grease to the inner control
cables at the point of entry and exit from their outer casings.

SPEED CHANGE CABLE

If the speed difference between the settings on the speed
change control are judged to be too little or do not exist at all
it may be necessary to adjust the cable.
1. Run the mower in the
2. If there is any play in the cable by nipple Y the cable must
be adjusted. Loosen the locking nut X and adjust the cable by
screwing out the nipple Y until the play on the cable is taken
up.
3. Tighten the locking nut X.
Note! Do not tension the cable more than necessary, it should
just sit in the nipple Y without play. Too much cable tension
will cause the drive belt to break or result in damage to other
parts of the transmission. When adjusting after maintenance
(e.g. fitting a new belt) always start with the nipple Y screwed
in fully.
MAINTENANCE
(Code 399S only)
position for a few minutes.
1.25
CS015
CS022
397011MA260599A