Canon HD XS HJ15ex8.5B Operation Manual page 51

LENSES
■ Setting the Zoom Track Positions
The first step which must be taken if the zoom track position is to be set is to set the zoom track
function to ON. To set this function to ON or OFF, refer to the previous page.
Instant Auto-Iris
Switch
1) If the zoom track position is to be set again, the zoom position cannot move beyond the end point
setting toward the mechanical end by performing servo zoom operations. To move the zoom, take
one of the steps below.
・Set the zoom track function to OFF. (See previous page)
・ Proceed with the zooming operation at the setting established by operating the zoom rocker
seesaw (see page E14).
・Perform the zooming operation manually.
2) Although up to two zoom track positions (Tele end and Wide end) can be set, two positions cannot
be set that are on the same side of the center position of the zoom range of this lens. (In this case,
the setting that was made last is stored as the zoom track position of this side.)
MEMO Button
s
E17 E17
1
Zoom to the zoom track position that you want to
set.
2
While holding this zoom position, press the Instant
auto-iris switch while holding down the MEMO
button. If the zoom position is at the Tele end with
respect to the center position of the zoom range for
this lens, the position is stored as the zoom track
position for the Tele end. If the position is at the
Wide end, it is stored as the zoom track position for
the Wide end.
3
Steps 1 and 2 are repeated to make the setting for
both the Tele and Wide ends. It is also possible to
make the setting for only one end.
4
To reset the zoom track position, perform steps 1
to 3 again. (The position setting that is made last
overwrites the setting in the memory.)
5 OPERATION