Table of Contents
Advertisement
5 OPERATION
5-1-3. Zoom Track Function
The zoom control range (zoom track) can be limited to selected zoom positions.
This function allows virtual settings to be made for the Tele end and Wide end. The zoom track func-
tion is enabled for all servo zoom operations. (This does not affect manual zoom operation.)
The first step which must be taken if the zoom track function is to be used is to set the function to
ON. There are two ways to set this function to ON or OFF. Refer to the following page for the
setting method.
■
Setting the Zoom Track Function to "ON" or "OFF"
A: Setting "ON" or "OFF" on the information display
MENU
IG:50
[Trk]OFF
Fr1P
A
Shtl
A 1
A2
[
Z.M. ]
[
I-Tq ] H
For details, refer to the Information Display Manual.
B: Setting "ON" or "OFF" by operating the switches
The zoom track function can be set to ON or OFF by operating the switch as shown below.
To set the
function to
"ON"
To set the
function to
"OFF"
Instant Auto-Iris
Switch
1
2
Fr1P
3
4
Push the Set key. This completes the setting.
Selection method
The zoom control range is fixed to the
zoom range set last.
Hold down the MEMO
setting, it is set to the mechanism end point.)
botton and Instant
auto-iris switch
The zoom range is set to the
simultaneously for at
mechanical end.
least 3 seconds.
MEMO Button
s
Push the DISPLAY switch to turn on the display.
Select [Trk] using the control key, and then push the Set key. [Trk]
and the last setting now blink on the display. (see left figure)
Move the left or right key to select ON or OFF.
Operation
(If there is no previous
E16
E16
How to ascertain the selection
Automatic zooming from
current zoom position to the
closer of the two set positions.
Automatic zooming from current
zoom position to the closer of
the two mechanical ends.
LENSES
Advertisement
Table of Contents
