Table of Contents
Advertisement
External DIP Switches
External DIP Switches
The ICX-250 is equipped with five external DIP switches (four - 12 dip
switches, and one - 7 dip switch) located on the rear panel of the unit.
These switches are used for Data Port and T1 Configuration. Each switch
is set to a preconfigured factory setting when shipped. The illustration
below outlines the location of these DIP switches.
ICX-250 - Rear Panel
Switch numbers S1 through S5 are shown on the board within the unit.
FXS Loopback
FXS Loop Pairs
1
S5
DIP Switch Settings
Locate the DIP switch on the rear panel that describes the function you
wish to effect. Use the tip of a small object to change the switch settings.
The switches will glide easily into place.
TIP
Switch setting
changes will
take effect
immediately.
Issue 1, September 1998
© 1998, ADC Telecommunications, Inc.
Note: The individual switches on each switch
assembly operate independently of one another.
12 13
24 Alm.
Data 1
S4
S3
Configuring the ICX-250
Data 1
T1 Line
Data 2
Data 2
T1
S2
S1
31
T1
24/48 VDC
Rx
+ – G
Tx
120 VAC–.6A 60Hz
11265-A
ADCP-62-023
Advertisement
Table of Contents
