ADC ICX-250 User Manual page 33

28 Configuring the ICX-250
FXS Ports - Trunk Conditioning
ON DIP
S19
1 2 3 4 5 6 7 8
S19
ON DIP
S18
1 2 3 4 5 6 7 8
S18
ON DIP
S17
1 2 3 4 5 6 7 8
S17
S7
ON
S7
1 2 3 4 5 6 7 8
S5 S4
Description: S6 position 6 and S7 position 6 selects the trunk conditioning state.
Factory Setting: IDLE
Idle: In the event of an alarm condition in the T1 connection to the network, the FXS Ports will be
put into the idle state immediately and remain in this condition until the T1 has been restored.
Idle Immediate/Busy Delay: In the event of an alarm condition in the T1 connection between the
ICX-250 and the network, the FXS Ports will be put into the Idle state immediately for 3 seconds
and then put into the Busy state and remain in this condition until the T1 has been restored.
The DIP switch settings shown in the illustration above are for Switch S6 and S7.
ADCP-62-023
© 1998, ADC Telecommunications, Inc.
( DIP switches - internal)
FRONT
ON DIP
1 2 3 4 5 6 7 8
S16
ON DIP
1 2 3 4 5 6 7 8
S15
ON DIP
1 2 3 4 5 6 7 8
S14
S6
DIP ON DIP
S6
1 2 3 4 5 6 7 8
S2
S3
BACK
S16
S15
S14
IDLE
ON DIP
1 2 3 4 5 6 7 8
ON DIP
1 2 3 4 5 6 7 8
IDLE/BUSY
S1
Issue 1, September 1998
Switches