2-Post Rack Installation - Lightspeed Systems Lightspeed Rocket Hardware Installation Manual

8.

2-Post Rack Installation

Unpack the appliance and locate the mounting hardware
Step 1
Locate the two long and six short rack
brackets that came in your ship kit.
A. Securely attach the set of short brackets
with the threaded screw holes to the
long bracket in the front as shown.
Use two M4 truss head screws for each
bracket.
B. Loosely attach one set of the other short
brackets to the long fixed bracket as
shown using one M4 truss head screw
on each bracket. The three holes on the
flap will face toward the back for later
attachment to the 2-post rack.
C. Loosely attach the remaining set of short
brackets to the long fixed bracket as
shown using one M4 truss head screw
on each bracket. The three holes on the
flap will face toward the front for later
attachment to the 2-post rack.
Step 2
Attach the assembled brackets to the
2-post rack.
A. Insert two M5 x 12 flat head screws
through the short brackets into the 2-post
rack (in the front and back of the rack as
shown) and tighten. Make sure the
brackets are aligned and level in height,
not only in the front and back but also on
the left and right sides.
B. Tighten each of the single screws on the
small fixed brackets (located on either
side of the rack) to secure the brackets in
the rack and ensure appliance stability.
Lightspeed Rocket Hardware Installation Guide
C
Small fixed
rack brackets
B
A
Small fixed
rack brackets with
threaded holes
Two M4 truss head screws
A
M5 x 12
A
flat head screws
(two front
and two rear)
B
NOTE: The following installation procedures
are for use with the rails and hardware
provided in your ship kit. If different style
rails are being used, or if your rack requires
different hardware, refer to the instructions
provided with your rail's or rack's ship kit.
Long bracket
C
B
A
NOTE: Once the assembled rails are attached
to the rack, securely tighten the single screws
on steps B and C.
*
A
B
Small fixed
rack brackets
One M4 truss
head screw
A
9