Safety Notes - Westfalia 82 63 73 Instruction Manual

Please note the following safety notes to avoid malfunctions,
damage or physical injury

Make sure the voltage corresponds to the type label on the device.

Persons with limited physical, sensorial or mental abilities are not allowed to
use the device, unless they are supervised and briefed for their safety by a
qualified person.

The sliding gate opener is designed for opening and closing light-weighted
sliding gates only. The sliding gate opener is designed for private use only.

The sliding gate opener is designed for operating sliding gates in vehicle
drives. Pedestrians must use a separate entrance.

Mounting, maintenance and repairs of the sliding gate opener must be
performed by a qualified person. According to EN 12635, a qualified person is
a person with suitable training, specialist knowledge and practical experience
sufficient to correctly and safely fit, test and maintain the gate system. In case
of failure of the sliding gate opener, a qualified person must be commissioned
immediately for the inspection or repair work. Observe the local safety
regulations to prevent accidents while mounting the sliding gate opener.
Westfalia assumes no liability for improper installation of the sliding gate
opener.

WARNING. There is risk on injuries if the sliding gate opener is not mounted
and operated correctly. Incorrect mounting and operation of the sliding gate
opener may trigger unexpected gate travel. Thus persons or objects can be
trapped.

Do not modify the sliding gate opener in any way.

Electrical installation has to be carried out by a qualified professional only.
Power supply of the sliding gate opener is provided by means of 230 V~ 50
Hz or by means of two batteries. Electrical power should be reserved only for
the sliding gate opener and should be protected by a 10 A fuse.

Check the whole sliding gate system (joints mounting material etc.) for any
signs of wear or damages and do not use the sliding gate opener with a
damaged sliding gate system resp. with signs of rust, fractures or corrosion.
Do not use the sliding gate opener unless repair work or alignment is carried
out properly.

Disable the existing sliding gate locks in order to avoid damages on the gate.

Ensure proper mounting when installing the sliding gate opener. Check the
sliding gate for proper manual operation. It is essential that the sliding gate
can be easily opened and closed by hand.

Safety Notes

2