Clutch Lever; Shift Pedal - Yamaha WR 155 Owner's Manual

Instrument and control functions
Hazard lights switch " /OFF"
The hazard lights (simultaneous flash-
ing of all turn signal lights) are used in
case of an emergency, such as to warn
other drivers when your vehicle is
stopped where it might be a traffic haz-
ard.
4
Set this switch to " " to turn on the
hazard lights. To turn off the hazard
lights, set the switch to "OFF".
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAUN2210

Clutch lever

1
ECA10062
1. Clutch lever
To disengage the drivetrain from the
engine, such as when shifting gears,
pull the clutch lever toward to the han-
dlebar. Release the lever to engage the
clutch and transmit power to the rear
wheel.
TIP
The lever should be pulled rapidly and
released slowly for smooth shifting.
(See page 6-3.)
EAU12823

Shift pedal

1
1. Shift pedal
The shift pedal is located on the left
side of the motorcycle. To shift the
transmission to a higher gear, move
the shift pedal up. To shift the trans-
mission to a lower gear, move the shift
pedal down. (See page 6-3.)
4-9
EAU12876