Filling The Engine With Oil - Toro 22186TE Operator's Manual

1. Higher handle position
Note: Torque all bolts to 120 in-lb (13.6 N-m).
3. Route the self-propel drive cable down the inside
of the handle, thread the cable through the opening
on the left hand side of the housing, and attach the
cable end (Figure 6).
1. Self-propel drive cable
2. Insert cable jacket end
here
4. Ensure that the self-propel drive
is properly adjusted; refer to
Adjusting the Self-propel Drive Cable (page 21).
5. Tie the loose cables to the handle (Figure 7) using
the cable tie from the loose parts bag.
Figure 5
2. Lower handle position
Figure 6
3. Attach cable end here
6. Install the back cover with the 2 screws you removed
in step 1.
2

Filling the Engine with Oil

Parts needed for this procedure:
SAE 30W detergent oil with an API service
20 oz.
classification of SH, SJ, SL, or higher (not supplied
(0.55 l)
with the mower)
Procedure
Important: This machine does not come with oil
in the engine.
Important: To read the dipstick in this machine
correctly, do not screw it in to the oil fill tube. Insert
the dipstick until the threads on the cap just touch
the threads in the oil fill tube.
1. Move the machine to a level surface.
2. Remove the dipstick, wipe it clean, and insert it back
into the oil filler tube just until it stops but do not
screw it in (Figure 8).
9
Figure 7
Figure 8