Table of Contents
Advertisement
2. Install a spacer onto both rear height–of–cut posts and
install the hairpin cotter pins.
2
3
Figure 11
1. Hairpin cotter
2. Spacer
3. On the opposite side of the muffler, install unused
spacers onto front and rear height–of–cut pins and
insert the hairpin cotter pins (Fig. 12).
3
2
1
Figure 12
1. Hairpin cotter
2. Unused spacers
Step
7
Checking the Tire Pressure
Parts needed for this step:
None
Procedure
Refer to page 33 for the correct correct tire pressure.
1
m–7584
3. Height–of–cut post (rear
shown)
m-6505
3. Height–of–cut post (front
shown)
18
Step
8
Checking the Hydraulic Fluid
and Engine Oil
Parts needed for this step:
None
Procedure
Check the hydraulic fluid level before the engine is first
started.
Refer to Checking the Hydraulic Fluid on page 34.
Check the engine oil level before the engine is first
started.
Refer to Checking the Engine Oil Level on page 29.
Step
9
Setting Up the Hydro Linkage
Parts needed for this step:
None
Procedure
Check the following adjustments when the machine is first
set up and adjust only as needed. Do them in the order that
they are listed here.
Checking the Speed Control Linkage
Refer to Adjusting the Speed Control Linkage on page 36.
Advertisement
Table of Contents
