Storage; Storing The Battery; Preparing The Machine For Seasonal Storage - Toro Reelmaster 3555 Operator's Manual

to the D position, and shut off the engine. After
ISABLE
completing adjustments, repeat steps
11. Repeat the procedure for all the cutting units that you
want to backlap.
12. When you are finished, return the backlap lever to
the M position, lower the floor panel, and wash
OW
all lapping compound off of the cutting units. Adjust
the cutting unit reel-to-bedknife contact as needed.
Move the cutting unit reel speed control to the desired
mowing position.
Important: If the backlap switch is not returned
to the F (Mow) position after backlapping, the
cutting units will not raise or function properly.
Note: For a better cutting edge, run a file across
the front face of the bedknife after lapping. This will
remove any burrs or rough edges that may have built
up on the cutting edge.

Storage

5 through 9.

Storing the Battery

If the machine will be stored more than 30 days, remove
the battery and charge it fully. Store the battery in a cool
atmosphere to avoid quick deterioration of the charge in the
battery. To prevent the battery from freezing, make sure
that it is fully charged. The specific gravity of a fully charged
battery is 1.265 to 1.299.
Preparing the Machine for
Seasonal Storage
Follow these procedures any time that you store the machine
for more than 30 days.
Preparing the Traction Unit
1. Thoroughly clean the traction unit, the cutting units,
2. Check the tire pressure. Inflate all tires to 83 kPa (12
3. Check all fasteners for looseness; tighten as necessary.
4. Grease or oil all grease fittings and pivot points. Wipe
5. Lightly sand and use touch-up paint on painted areas
6. Service the battery and cables as follows:
48
and the engine.
psi).
up any excess lubricant.
that are scratched, chipped, or rusted. Repair any dents
in the metal body.
A. Remove the battery terminals from the battery
posts.
B. Remove the battery.
C. Slowly recharge the battery before storage and
every 60 days thereafter for 24 hours to prevent
lead sulfation of the battery.
To prevent the battery from freezing, make sure
that it is fully charged. The specific gravity of a
fully charged battery is 1.265 to 1.299.
D. Clean the battery, terminals, and posts with a wire
brush and baking soda solution.
E. Coat the cable terminals and battery posts with
Grafo 112X skin-over grease (Toro Part No.
505-47) or petroleum jelly to prevent corrosion.
F. Either store it on the shelf or on the machine in
a cool area. Leave the cables disconnected if it is
stored on the machine.