Specifications; Attachments/Accessories; Operation; Checking The Level Of The Engine Oil - Toro Reelmaster 3555 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Dimensions
Width of Cut
Overall Width
Transport Width
Overall Length
Height to top of ROPS
Wheel Base
Weight (configured)
Weight (no cutting units)

Attachments/Accessories

A selection of Toro approved attachments and accessories is available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
To best protect your investment and maintain optimal performance of your Toro equipment, count on Toro genuine parts.
When it comes to reliability, Toro delivers replacement parts designed to the exact engineering specification of our equipment.
For peace of mind, insist on Toro genuine parts.

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.
Checking the Level of the
Engine Oil
Service Interval: Before each use or daily
The engine comes with oil in the crankcase; however, you
must check the oil level before and after you first start the
engine.
The crankcase capacity is approximately 3.8 L (4 US qt) with
the filter.
Use high-quality engine oil that meets the following
specifications:
•
API classification level required: CH-4, CI-4, or higher.
•
Preferred oil: SAE 15W-40—above 0ºF (-17ºC)
•
Alternate oil: SAE 10W-30 or 5W-30—all temperatures)
Note: Toro Premium Engine oil is available from your
distributor in either 15W-40 or 10W-30 viscosity. Refer to the
parts catalog for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level is
Reelmaster 3555
254 cm (100 inches)
284 cm (112 inches)
231 cm (91 inches)
267 cm (105 inches)
201 cm (79inches)
152 cm (60 inches)
1034 kg (2280 lb)
751 kg (1655 lb)
at or below the Add mark on the dipstick, add oil to bring the
oil level to the Full mark. Do not overfill the engine. If the
oil level is between the Full and Add marks, no oil addition
is required.
1. Position the machine on a level surface.
2. Remove the dipstick
clean rag.
1. Dipstick
3. Push the dipstick down into the dipstick tube and make
sure that it is seated fully. Pull the dipstick out and
check the oil level.
4. If the oil level is low, remove the oil-fill cap
and gradually add small quantities of oil, checking the
22
Reelmaster 3575
254 cm (100 inches)
284 cm (112 inches)
231 cm (91 inches)
267 cm (105 inches)
206 cm (81 inches)
152 cm (60 inches)
1157 kg (2550 lb)
796 kg (1755 lb)
(Figure 27) and wipe it with a
Figure 27
(Figure 28)