Table of Contents
Advertisement
7
Update
A firmware update is carried out via the importing of a micro SD card. The update file must be
transmitted to the micro SD card beforehand. This file can be downloaded in the e-catalogue.
To update the firmware, carry out the following steps:
1. Remove the support frame from the device.
–
The electric voltage is disconnected automatically.
Fig. 27:
SD card slot
3. Attach the device again to the support ring.
–
The device is connected again to the power and the boot-up process starts.
Fig. 28:
Card icon on the screen
5. Select the correct update file.
–
The update is carried out automatically.
Product manual 2CKA001473B9085
2. Insert the micro SD card into the
device until it engages.
–
1
4. Press the card icon [1] on the screen.
–
The micro SD card fits only into
the corresponding slot
A dialogue field opens.
Update
│28
Advertisement
Table of Contents
