Table of Contents
Advertisement
6.3
Specifying or editing functions (buttons)
The settings are made via the panel configuration of the Web-based user
interface of the System Access Point.
In the panel configuration the buttons of the device can be freely equipped. All panels installed
in the system can be selected from the bottom selection bar.
Only panels are listed that have been previously positioned on the floor plan under
commissioning step "Allocation"!
The allocated actuator channels can be positioned on the panel via drag-and-drop from the list
view. After the confirmation the configuration is taken over and becomes visible on the device
after a few seconds.
6.3.1
Creating functions
Fig. 17:
Panel selection
1. If several panels are available, first select the appropriate panel [1].
Fig. 18:
Actuator/group selection
Product manual 2CKA001473B9085
Commissioning
2. Select a floor in the list view.
3. Select a room on this floor.
–
The actuators and groups
contained in the selected room
are displayed in the list view.
│24
Advertisement
Table of Contents
